Card and Paper - A4 gold pearlescent card;

Embellishment - Topper 16-11;

Peeloff Stickers - Decorative Lines - gold;

Peeloff Sticker - Alphabet Tiles - silver;

Piece of red paper;

Scrap of white paper;

Decorative edge scissors.

How to make :-

Cut the A4 gold pearlescent card in half to make two A5-sized pieces of card. Use one of these pieces to make the card blank. Score and fold this A5 piece 5.25cms in from either edge. This is then your gate-fold card blank. Cut two strips of red paper approximately 1cm wide and 15cms long and then trim one edge of each strip with the decorative edge scissors. Glue each strip very close to the central edges of the card front as shown. Place the peel-off, decorative lines, onto the top of the red strips. Fix the topper to the left-hand edge of the card blank. Take two small hearts from the vellum sticker sheet and fix them to the scrap of white paper. Cut around the hearts to leave a narrow border of white and glue them as shown to the card. Finish by placing the alphabet tile peeloff letters to the top-left and bottom-right of the Topper to spell the words 'Be Mine'.

Card and Paper - White 6" square card blank, black card for mount and for stamping

Scrapbooking, Sandylion Blackcheck paper

Rubber Stamp - Woodware Geometric Heart

Versamark pad, anti-static bag, heat tool

Black detail embossing powder

Foam pads

Silver peel-off lines

White gelly roll pen

Cuttlebug heart blocks embossing folder

Cut a diagonal piece off your front card panel.. Cut a piece of black card - approx. 5" square.

Cut black check paper to 4.5" and stick to the black card - edge with silver peel-off lines. Attach this piece onto the front of the white card blank.

Card and Paper - A4 white card;

Hot Off the Press - A4 paper Kisses (used to make the shirt)

Minature Buttons

Decorative Peel-off lines - silver

SAK stamp

Orchid cats eye ink

Card and Paper - A4 red card;

Hot Off the Press - A4 paper Kisses

Die-cut Nested Heart

Ribble wire

Decorative Peel-off lines - silver

Card and Paper - A4 white card, red card, Mulberry paper - red printed hearts.

Pewter Heart brads (or gems)

Die cut Sillhoutte twin hearts wrapped in silver ribble wire

Sheer red ribbon

Stamped and cut-out hearts (using heart stamp)

Dye Ink Chalk eye - red

Card Blanks - Square Pearlescent - white;

Die-cut - Heart - mixed colours;

Printed Vellum - Hearts - gold;

Glistened Vellum - bordeaux

Peeloff Stickers - Decorative Lines - gold;

Vellum Sticker - True Love;

Embellishment - Open Rose - yellow;

Tools and Glues - 3-D Foam Tape Squares, vellum tape;

Small length of gold or silver thread.

How to make :-

Cut a piece of the printed vellum - hearts, 6cms x 12cms and use the vellum tape to tape it to the left-hand edge of the card front. Place the 'True Love' design from the vellum sticker pack in the bottom right corner of the card. Place the decorative line peeloffs to the left and right sides of the card as shown. Lay the cream die-cut heart onto the glistened vellum and cut around leaving a narrow margin so as to create an identical but slightly larger heart. Glue the glistened vellum heart onto the card at an angle as shown. Fix a length of thread to the underside of the cream heart with sellotape and wind randomly around it. Fix the end to the back of the heart again with sellotape and then fix the cream heart on top of the glistened vellum heart with 3-D Foam squares. To finish place any small vellum sticker motif in the top left of the heart and glue a single open rose to the bottom of the heart.